Page 1 of 1

VPN Client virtual switch set up

Posted: Thu Aug 13, 2020 8:57 am
by shamz84
[wiki][/wiki]Hey guys....I recently bought my self a new QNap and looking to configure it.

What I'd like to do is run a VPN client on the QNap and route certain traffic through that.

So When setting up the VPN client...it's doesn't seem i can use it for only one network adapter...it's had to be used via the default gateway...I'm guessing that means all my traffic with go through this?

Is that correct or am I missing something?

Also I was looking at the virtual switch...so what I wanted to do is

Have the VPN attached the network adapter 2. Then my chosen container will go there the VPN...bit couldn't figure out how that is achievable


Thanks for your help.

Re: VPN Client virtual switch set up

Posted: Sat Aug 15, 2020 4:04 am
by RichJacot
I'd be interested in this also. Subscribed.

Re: VPN Client virtual switch set up

Posted: Thu Sep 03, 2020 6:33 pm
by sszben
I would be interested too!
I would like to use adapter2 to share the VPN connection with other devices via cable.