[SOLVED] 4.3.5.0722 firmware is broken after update HDD Spindown stop work

Discussion about hard drive spin down (standby) feature of NAS.
Post Reply
User avatar
PeterMac83
Starting out
Posts: 28
Joined: Mon Jun 25, 2018 10:33 pm

[SOLVED] 4.3.5.0722 firmware is broken after update HDD Spindown stop work

Post by PeterMac83 » Sun Oct 14, 2018 12:20 am

Latest 4.3.5 firmare update is a piece of **, brake HDD Spindown, before update HDD's goes sleep after selected time in Options, now this not work again.
TS-231P firmware 4.3.5.0722

User avatar
PeterMac83
Starting out
Posts: 28
Joined: Mon Jun 25, 2018 10:33 pm

Re: 4.3.5.0722 firmware is broken after update HDD Spindown stop work

Post by PeterMac83 » Sun Oct 14, 2018 5:57 am

Problem solved, I restart to default settings, and once again off what is posibble exepct Windows SMB access and now sleep fine like before.

DarkSchneider
Starting out
Posts: 14
Joined: Mon Oct 01, 2018 5:06 pm

Re: [SOLVED] 4.3.5.0722 firmware is broken after update HDD Spindown stop work

Post by DarkSchneider » Tue Oct 16, 2018 5:02 pm

Same here, as mentioned in its thread:

https://forum.qnap.com/viewtopic.php?f=55&t=143735

After updating, it continues to spins up by its own very often.

Then, we have to restore factory setting after each firmware upgrade? It is much work to configure everything again and again. Because restoring a saved configuration could reach to the same problem, as it is supposed you restore all the settings which made your device not going to standby.

DarkSchneider
Starting out
Posts: 14
Joined: Mon Oct 01, 2018 5:06 pm

Re: [SOLVED] 4.3.5.0722 firmware is broken after update HDD Spindown stop work

Post by DarkSchneider » Wed Oct 17, 2018 2:56 pm

@PeterMac83 a question, your device does not wake up frequently by its own, even when no access to it? Mine does.

Post Reply

Return to “HDD Spin Down (HDD Standby)”